Tray Designer
Create a serving tray with finger joints: low long walls, raised end walls with an arc, slopes or a straight top – and handle cutouts in three shapes. Choose dimensions, material thickness and finger width, check the result in 2D and 3D and export the cut files.
Dimensions
Dimensions incl. material thickness (overall size)
Overall width of the tray (length of the long walls)
Overall depth of the tray (length of the end walls)
Outer height of the long walls (incl. bottom)
Additional height of the end walls above the long wall at the center
Shallow circular arc from the corners to the peak
Material
Thickness of the material used (e.g. plywood)
Finger joints
Target width of each finger and notch
Minimum number of fingers per joint edge
Handle cutouts
Width of the handle cutout
Height of the handle cutout
Distance from the peak of the end wall to the top of the cutout (at least one material thickness of web)
Layout
Gap between parts in the layout
End Wall Profile
Choose between a shallow circular arc, slopes with a flat center section or a uniformly taller end wall. The rise above the long walls is fully adjustable.
Handle Cutouts
Centered handle cutouts in both end walls as a slot, ellipse or rectangle with corner radius. Width, height and distance from the top are freely selectable – the web to the edge always stays at least one material thickness.
Finger Joints All Around
Bottom, long walls and end walls interlock with finger joints. Finger width and minimum count adapt to your material thickness.